Fan User Manual

2007 PORT-A-COOL® Unit Electric Models

SPRAY BAR ASSEMBLY (ALL MODELS)

SUBMERSIBLE PUMPS PROBLEM CHECK SOLUTION

PROBLEM CHECK SOLUTION

Too many dry streaks in the pads. Holes in spray bar blocked

Remove and clean spray bar.

by foreign material.

Clean individual holes.

Water spitting from the unit. Hose connection loose. Tighten hose.

Replace hose and washer.

Reseat spray bar end caps

Excess water in air Pad Installation Pads must be installed

coming from the fan. according to air flow

direction label on the pad.

PROBLEM CHECK SOLUTION

Pump will not run when switch Power cord, switches, Reconnect power,

is turned on. circuit breaker, reset breaker

switch box, connection, etc. or reconnect in switch box.

Air lock in hose. Disconnect hose at base of

pump, run pump to release

air, then reconnect.

Pump hums when switch is Inlet filter clogged. Clean filter.

turned on, but does not Pump motor locked. Replace pump.

pump water. Other items on circuit. Remove other items.

Breaker trips or fuse blows Wiring short in line between Check and/or replace wiring.

when switch is turned on. pump and switch box.

Pump cycling on and off Sump tank is empty. Fill with water.

periodically Spray bar valve is closed. Open valve.

Pump will not run and power is Switch making closure contact. Check continuity/

available and pump is functional. Replace switch.