Use and Care Manual

2009 PORT-A-COOL® Unit Electric Models

B. Repair and Replacement Procedures

Ensure that all water is removed from the PORT-A-COOL® unit and all power is disconnected. Remove all

impediments to access the component you are checking or replacing.

REPLACING THE COOLING MEDIA (Pads) (All Models)

Caution - Disconnect power before performing this operation!!

The flap must be removed to allow access to the cooling pads. Start with the center pad, which should

be tilted out from the top and lifted out of the drain trough. The two pads to either side of the center pad

may then be removed in the same manner. Should you desire to remove the two outside pads, they must

first be pulled sideways toward the center of the PORT-A-COOL® unit until they clear the side retainer.

They may then be removed in the same manner as the other pads.

Locate the set screw

in the rear of the unit

on the upper right

side

Remove set screw

and lower front flap

to vertical

position (see

illustration)

Once the front flap

is moved, grasp the

right pad and tilt out

at a 90 degree angle

(see illustration).

Pull the pad up to

remove from unit.

Repeat for other

pads.