Use and Care Manual

PORT-A-COOL JETSTREAM™ OWNERS MANUAL

The Port-A-Cool Jetstream™ 1600 model

is pre-assembled and ready to operate. Sim-

ply remove the packaging and then care-

fully roll the unit from the box.

Connecting to water. Move the cooler to

an area where it can be lled with water and

drained. The cooler should be located on

level ground. Connect to a water supply using

a commercial grade garden hose (supplied

by customer). Simply attach the hose to the

adapter located on the left side of the unit (see

gure 1). Verify water tight connections by

visually examining the hose connection and

the drain plug.

The Port-A-Cool Jetstrream™ 1600 also features the ller cap option (see

Figure 1 above) that holds 40 gallons of water for increased portability.

CAUTION: Water inlet pressure should be limited to a maximum 50 PSI.

Connecting to a power supply. When making electrical connections

insure that local and national codes are adhered to. Use only with GFCI

Protected Receptacles. Please refer to the Barcode Product Label on the

side of the unit for specific electrical requirements.

LOCATION OF COOLER

Always make sure the unit is operated on a level surface. When using

the cooler indoors, the best location is near a partially opened window

or door where hot outdoor air can be drawn into the unit. The Port-A-

Cool Jetstream™ 1600 is portable, but use caution when rolling the unit

to avoid splashing and spilling of water. Cool air can best be directed

through the space by using a partly opened window or door, ideally

one that is situated on the opposite side of the space from the cooler.

This allows the cooled air to be moved through the space and exhausted

back outdoors which is critical to proper operation of the cooler.

PAGE

Figure 1

SETUP INSTRUCTIONS