Use and Care Manual

PORT-A-COOL JETSTREAM™ OWNERS MANUAL
Periodic draining of the pump will help reduce the build-up of calcium
deposits on the pad and pad frame. Periodic cleaning of the pads will
also help increase the life of the pads and the cooling performance of
the cooler. Do not attempt to clean the pads while they are installed
in the pad frames or in the cooler. They must be completely removed
from the cooler (see Küül® Pad Replacement on this page) and then
can be hosed off and lightly brushed to remove or reduce the calcium
build-up. Pads must be replaced, though, if the calcium build-up starts
to completely block air passages through the pad.
The cooling pads should be changed at least every two years. Check
and clean them at the beginning of the season. The pads may need to
be replaced more frequently depending on local conditions and the
maintenance schedule followed.
Replace cooling pads as follows:
CAUTION - DISCONNECT POWER BEFORE PERFORMING THIS OPERATION!!
The flap must be removed to allow access to the cooling pads. Start
with the center pad, which should be tilted out from the top and lifted
out of the drain trough. The two pads to either side of the center pad
may then be removed in the same manner. Should you desire to re-
move the two outside pads, they must first be pulled sideways toward
the center of the Port-A-Cool Jetstream™ 1600 unit until they clear the
side retainer. They may then be removed in the same manner as the
other pads.
PAGE 5
KÜÜL® PAD MAINTENANCE
KÜÜL® PAD REPLACEMENT