User's Manual

ManualsBrandsPorta Phone ManualsElectronicsDECT Belt Pack Transceiver

Page 1

FULL DUPLEX DECT SYSTEMS

user manual

Introduction

Thank you for your choice of Full Duplex DECT Systems.

This is a DECT (Digital Enhanced Cordless Telecommunications) duplex wireless system. To the quality of

audio and to the safety offered from the digital technology, The offers manifold and useful features including

Full duplex system, LED In use illumination, multi-headset capabilities and multi-volume select. Please read this

instruction carefully before using your new system for the first time.

A glance guide for the headset

A glance guide for the base unit

Installation

Please check your package the following items(options):

-Base Unit (THE HUB HD/ UltraLite HD-M/ UltraLite HD-MD)

-Wireless Headset (UltraLite HD-R/ UltraLite HD-RD/ UltraPAK)

-Wire Headset (Max4GS/ Max4GD)

-AC/DC adaptor for Base Unit(5V/1A)

- Packing batterie(800mAH/3.7V)

Choose a suitable site for the base unit, make sure it is not near to other electrical equipments.

Connect the AC adaptor socket to the Base Unit and the power socket. Turn on the power of base.

UltraLite HD-R

Battery pack

ower on/off

Vol down

Vol up

eceiver

UltraPAK

UltraLite HD-RD

THE HUB HD

Power on/off

Vol up

Vol down

EarJack

Conference indicator

All Conference

Battery

Connector for wire Headset 1

Connector for

wire

Power switch/VOL

DC Jack 5V

Battery pack

SUB key

Vol up

Vol down

Battery pack

UltraLite HD-M

UltraLite HD-MD

Summary of content (5 pages)

PAGE 1
FULL DUPLEX DECT SYSTEMS user manual Introduction Thank you for your choice of Full Duplex DECT Systems. This is a DECT (Digital Enhanced Cordless Telecommunications) duplex wireless system. To the quality of audio and to the safety offered from the digital technology, The offers manifold and useful features including Full duplex system, LED In use illumination, multi-headset capabilities and multi-volume select. Please read this instruction carefully before using your new system for the first time.
PAGE 2
Wire Headset UltraliteHD-R SUB key2 UltraliteHD-R SUB key1 UltraliteHD-M / Max4GS UltraliteHD-MD UltraliteHD-RD UltraPAK THE HUB HD Max4GD UltraliteHD-RD UltraPAK The pack rechargeable batteries come with your charger. -Insert the rechargeable battery into the headset as the above figure indicated, matching correct polarity. -Fit the battery compartment cover by sliding it down so that it clicks firmly into place. NOTE: Reversing the orientation may damage the headset.
PAGE 3
Out of range indication If your headset has registered and is in located range, the “In use” LED will blanking steadily, when your headset goes out of range, the communication link will be lose temporarily, the “In use” LED will blink. If you go back to the located range again, the communication link will restore, also the “In use” LED will blanking steadily. Note: your talk will be cut without any audible warning tone if you are in a talk and out of the located range.
PAGE 4
Exposure to Radio Frequency (RF) Signals This device is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission (FCC) of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on the safety standards previously set by both U.S. and international standards bodies.
PAGE 5
Specific Absorption Rate (SAR) information SAR tests are conducted using standard operating positions accepted by the FCC with the phone transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value.