PORTACOOL CYCLONE OWNER’S MANUAL PAC2KCYC01, PACCYC02, PACCY110, PACCY120, PACCY130, PACCY160 * * Applies to all 120 and 240V products for global configurations
QUICK SETUP 1 2 Remove product from packaging 5 Position on level surface For setup, KUUL ComfortTM evaporative media should appear wet before starting the fan. Check the water gauge to monitor water level in tank. The water adjustment valve on each portable evaporative cooler is set at max flow. However, ensure the knob is turned completely to the right before use. Turn to the left to increase water flow.
SAFETY OPERATION WARNINGS 1) Not for use by children 2) Not for use by persons with reduced physical, sensory or mental capabilities 3) Not for use by persons who have not reviewed the owner’s manual and familiarized themselves with the operation of the product SAFE OPERATION To reduce the risk of electric shock, fire or injury: • Do not operate any evaporative cooler with a damaged cord or plug. • Do not run power cord under carpeting or cover with throwrugs, runners or similar coverings.
OVERVIEW PORTACOOL CYCLONE ™ 2000 Control panel Serial plate Adjustable louvers Liquid Level Indicator KUUL Comfort™ evaporative media Fill door Water adjustment valve Power cord with GFCI Hose connection Casters Drain located in back
OVERVIEW PORTACOOL CYCLONE ™ 3000 Control panel Adjustable louvers Liquid Level Indicator Serial plate KUUL Comfort™ evaporative media Fill door Hose connection Water adjustment valve Power cord with GFCI Casters Drain located in back
OVERVIEW Water adjustment valve PORTACOOL CYCLONE ™ 110 Control panel Adjustable louvers KUUL Comfort™ evaporative media Serial plate Liquid Level Indicator Power cord with GFCI Fill door Recessed casters Hose connection Drain located in back
OVERVIEW PORTACOOL CYCLONE ™ 120 Adjustable louvers KUUL Comfort™ evaporative media Control panel Liquid Level Indicator Serial plate Water adjustment valve Power cord with GFCI Fill door Casters Hose connection Drain located in back
OVERVIEW PORTACOOL CYCLONE ™ 130 Adjustable louvers KUUL Comfort™ evaporative media Serial plate Control panel Water adjustment valve Power cord with GFCI Liquid Level Indicator Fill door Casters Hose connection Drain located in back
OVERVIEW PORTACOOL CYCLONE ™ 160 KUUL Comfort™ evaporative media Serial plate Control panel Water adjustment valve Power cord with GFCI Liquid Level Indicator Casters Hose connection Drain located on bottom
GFCI The Portacool Cyclone™ series utilizes a GFCI (Grounded Fault Circuit Interrupter) to help protect users against ground electrical faults, which prevent some fire and electrical shock hazards. These devices are intended to trip at very low leakage currents. Portacool Cyclone models PAC2KCYC01, PACCYC02, PACCY160, PACCY130, PACCY120 and PACCY110 use a GFCI, which is built into the power cord.
LLI LIQUID LEVEL INDICATOR / PUMP SHUTOFF A liquid level indicator with integral shutoff gives a visual indication of the water level in the evaporative cooler and will shut off the pump once the water reaches a certain threshold. When this occurs, a red light on the control panel will illuminate to draw attention to the low water level condition and alert the user that the pump has shut off.
START UP PLACEMENT 1) Make sure there is a clear, unobstructed path in front of the evaporative cooler to provide maximum airflow. 2) If the evaporative cooler is positioned on a raised platform, ensure the platform is stable, well constructed and will not allow the evaporative cooler to tip over. Ensure it allows for the full weight of the evaporative cooler, including a tank full of water.
MAINTENANCE While the rugged, corrosion-resistant construction ensures low maintenance will be required, keeping your evaporative cooler clean will ensure it stays in peak operating condition. DAILY MAINTENANCE The pump should be turned off approximately 15 minutes before the fan is turned off, which allows the KUUL® evaporative media to dry.
TROUBLESHOOT Turn off all power to your evaporative cooler before attempting to troubleshoot any of the following symptoms. For problems not listed, please contact customer service. REMEDY SYMPTOM POSSIBLE CAUSES Evaporative cooler fails to start or deliver air 1. No electricity to the evaporative cooler A. Circuit breaker tripped B. GFCI tripped C. Power unplugged or damaged 1. Check power A. Reset breaker* B. Reset GFCI** C. Plug in cord(s) or replace if damaged 2.
TROUBLESHOOT SYMPTOM POSSIBLE CAUSES REMEDY Musty or unpleasant odor 1. Stale or stagnant water in tank 1. Drain, flush and clean tank 2. KUUL evaporative media is mildewed or clogged 2. Replace KUUL evaporative media 1. Too much water delivered to KUUL evaporative media 1. Make sure KUUL evaporative media is properly positioned in the frames and evaporative cooler is level 2. Leaking hose 2. Tighten connection or replace hose Water droplets in the air stream ORDER PARTS ONLINE portacoolparts.
WARRANTY TECHNICAL SUPPORT Technical support and service is available directly from your distributor or call Portacool, LLC Technical Support at (800) 695-2942 for the distributor nearest you. You may also contact Support for consultation on troubleshooting and parts replacement. Please have serial number and model number of evaporative cooler available.
PORTACOOL PROTECT Portacool, LLC is proud to provide world-class service and support. Portacool Protect™ brings together our commitment to service and support in the form of best-in-class warranties, service programs, technical support and live customer service to provide our customers with an ownership experience that is second to none.
FAQ Q. What assembly is required? A. None. Portacool Jetstream evaporative coolers are ready to use right out of the box. Q. How do I prepare my evapoartive cooler for storage? A. Drain the evaporative cooler, dry out the evaporative media, cover the evaporative cooler and store in a dry place. Q. I just ran my evaporative cooler for the first time and there is an unplesant odor. A.
FAQ Q. Where are the model and serial numbers found? A. The model number can be found on a metal plate on the outside of the evaporative cooler. Model numbers begin with the letters “PAC.” Serial numbers are all digits. Q. What if my questions are not answered here? A. Check out our videos on www.portacool.com or our YouTube channel. Our U.S.-based Tech Support staff is available 8 a.m. to 5 p.m. Central Time, Monday though Friday at (800) 695-2942 or you can e-mail them at support@portacool.com.
PARTS 2000 3000 110 120 130 160 MOTOR-016-01 MOTOR-013-07B PARMTRCY110A PARMTRCY120A PARMTRCY130A PARMTRCY160A PUMP PUMP-CYC-3 PUMP-CYC-3 PARPMPCYC00A PARPMPCYC00A PARPMPCYC00A PARPMPCY160A MEDIA PARKULCYC200 PARKULCYC300 PARKULCY1100 PARKULCYC200 PARKULCYC300 PARKULCY1600 CONTROLS CTRL-2SPD-01 CTRL-2SPD-01 PARCTLCY110A PARCTLCY110A PARCTLCY110A PARCTLCY160A PAC-CVR-C2 PAC-CVR-02 PARCVRCYC06 PAC-CVR-C2 PAC-CVR-02 PAC-CVR-01 PARPACHWTB00 PARPACHWTB00 PARPACHWTB00 PAR
NOTES
NOTES
NOTES
CUSTOMER SERVICE CONTACT 1-936-598-5651 • 1-800-695-2942 SUPPORT@PORTACOOL.COM TECHNICAL/PARTS CONTACT 1-936-598-5651 • 1-800-695-2942 SUPPORT@PORTACOOL.COM VISIT PORTACOOL.COM The manual is available in other languages. To download a digital copy, please visit www.portacool.com. El manual está disponible en otros idiomas. Para descargar una copia digital, por favor visite www.portacool.com. Le manuel est disponible en d’autres langues.