Use and Care Manual

SETTING THE STANDARD IN EVAPORATIVE COOLING MEDIA
KÜÜL® evaporative cooling media is manufactured in the USA by Port-A-Cool, LLC
Maintenance Guide
KÜÜL® pads are a durable and long lasting cooling media. Following are sugges-
tions that will maximize the life and efficiency of the cooling pads.
• Port-A-Cool,LLC,recommendsthatthepH of the water be maintained at a level
between 6 and 8. Exceeding these limits will seriously deplete the resin content of the
pad and thus reduce its structural integrity.
• Removeandbrushpadswithasoftbristledbrushandthenflush system to remove
debris.Thisshouldbedoneevery4to6weeksduringoperatingseason.
• Aclean water distribution system is the most important
aspectformaintainingtheentireevaporativecoolingsystem.
 This,coupledwithquarterlyinspection/maintenance
 checks,willensureaproperlyoperatingevaporative
cooling system.
• Frequently check system for damaged or clogged cooling pads.
• Minimize the number of on/off wetting cycles for the
cooling pads.
• Completelydry the cooling padsonceevery24hours.
• Maintainawater bleed off rate of 3-5% per day.
• Ensuresumptankisenclosedandcleanedbi-weekly.
• Cleanwaterfiltersweekly.
[phone] • [phone]
P.O. Box 2167 • Center, TX 75935 • Fax [phone] • www.kuulpads.com • [e-mail]
Revised: August 27,2012
KÜÜL® pads are manufactured by Port-A-Cool, LLC in the U.S.A.