Instructions / Assembly

Remove product from packaging Position on level surface
Fill tank or attach water hose
1 2 3
PORTACOOL EVAPORATIVE COOLER
QUICK SETUP SHEET
Plug into appropriate outlet
Fill the tank, then turn on the pump switch and the fan
For setup, KUUL Comfort
TM
evaporative media should
appear wet before starting the fan. Check the water
gauge to monitor water level in tank. The water
adjustment valve on each portable evaporative cooler
is set at max ow. However, ensure the knob is turned
completely to the right before use. Turn to the left to increase
water ow. If entrainment occurs - water is spitting from the
front of the product - use the valve to decrease the water ow
until entrainment ceases.
4
5
Your Portacool portable evaporative cooler is meant to
be used in an open-air environment, such as a patio.
If you plan to use your evaporative cooler in a more
closed environment – such as a garage, sunroom or
barn – you must provide adequate ambient airow to ensure
your evaporative cooler works at its highest efciency. When
using in a semi-closed environment, be sure to leave a door or
window open to allow for the proper amount of airow.
6
Ensure proper airflow is available
OPERATION WARNINGS
SAFE OPERATION
1) Not for use by children
2) Not for use by persons with reduced physical, sensory or mental capabilities
3) Not for use by persons who have not reviewed the owner’s manual and familiarized themselves with the operation of the product
To reduce the risk of electric shock, re or injury:
• Do not operate any evaporative cooler with a damaged cord
or plug.
• Do not run power cord under carpeting or cover with
throwrugs, runners or similar coverings. Arrange power cord
away from trafc areas to avoid tripping hazards.
• Read the evaporative cooler’s instructions, owner’s manual
and labels thoroughly before use.
• Always unplug the power cord to the evaporative cooler
before performing inspections or repairs.
• Do not step on or roll over power cord with heavy or sharp
objects.
• Do not operate evaporative cooler unless all KUUL
®
evaporative media is securely in place.
• Test the GFCI receptacle or breaker monthly to ensure it is
functioning properly.
• Remove the plug from the electrical receptacle by pulling on
the plug, not the power cord.
• Operation near open flames or sparks is not recommended.
• If operating near open flame or sparks, ensure the pump
is continuously running in order to saturate and wet KUUL
evaporative media.
• When cleaning your evaporative cooler, ensure water does
not get into the motor or electrical system to prevent
damage.
• The use of extension cords with your evaporative cooler is
not recommended. However, if the owner determines that
his or her circumstance or intended use requires the use of
an extension cord, the following requirements must be met:
- Extension cord must be 14 gauge or greater;
- Extension cord must not exceed 50 (15.24 meters)
feet in length; and
- Extension cord must be properly grounded.
• Evaporative coolers should not be modified in any way
(other than repairs made by qualified individuals with
Portacool replacement parts).
• If the evaporative cooler is damaged or malfunctions,
do not continue to operate it. Refer to the warranty,
troubleshooting or FAQ sections of this owner’s manual,
call Portacool, LLC Customer Service at [phone] or
[phone], or email [e-mail].
SAFETY PRECAUTIONS