Owner manual

Setting Maximum Sensitivity for Banner SBL1 Sensor’s

With your track powered and power to your sensors remove the white protective

dust cap using a flat head screw driver.

This will expose a small brass screw. This is the sensitivity adjustment

potentiometer.

PAGE 1
Setting Maximum Sensitivity for Banner SBL1 Sensor’s With your track powered and power to your sensors remove the white protective dust cap using a flat head screw driver. This will expose a small brass screw. This is the sensitivity adjustment potentiometer.
PAGE 2
Sensitivity adjustment screw Using a small jewelers type flat head screw driver slowly adjust the sensitivity of the sensor. Turning the screw head clockwise will increase sensitivity, turning the screw head counter counter-clockwise will decrease sensitivity. Adjust the sensitivity so that when the palm of your hand is one inch away from lens the sensor is activated. The red LED will illuminate when the sensor is activated.
PAGE 3
Sensor aligned ½” to 1” Sensor not aligned or not powered 2” to 3” When your sensor is set to maximum sensitivity make sure to screw back in the white protective dust cover before use to ensure water and dirt does not get inside the sensor. NOTE: All SBL1 sensors shipped from Portatree are already adjusted for maximum sensitivity.