Table Saw INSTRUCTION MANUAL (Model TS220LS)

1818

STARTING AND STOPPING SAW

1. The on/off switch is located underneath the switch

shield (A) Fig. 36. To turn the saw “ON”, move switch

trigger (B) up to the “ON” position.

2. To turn the saw “OFF”, push down on switch shield

(A) Fig. 37.

LOCKING SWITCH IN

THE “OFF” POSITION

IMPORTANT: WHEN THE TOOL IS NOT IN USE, THE

SWITCH SHOULD BE LOCKED IN THE OFF

POSITION USING A PADLOCK (C) FIG. 38, WITH A

3/16" DIAMETER SHACKLE TO PREVENT

UNAUTHORIZED USE.

OVERLOAD PROTECTION

Your saw is equipped with a reset overload relay button

over loading (cutting stock too fast, using a dull blade,

using the saw beyond its capacity, etc.) or low voltage,

turn the switch to the “OFF” position. Let the motor cool

three to five minutes and push the reset button (C),

which will reset the overload device. The motor can then

be turned on again in the usual manner.

BLADE RAISING AND

LOWERING CONTROL

To raise or lower the saw blade, turn handwheel (A) Fig.

39. Turning the handwheel clockwise lowers the blade

and turning the handwheel counterclockwise raises the

blade.

THE BLADE TILTING LOCK HANDLE

(B) FIG. 39, MUST BE LOCKED DURING ALL

CUTTING OPERATIONS.

Fig. 36

Fig. 37

Fig. 38

Fig. 39

OPERATING CONTROLS AND ADJUSTMENTS