Use and Care Guide
14
ASSEMBLY AND ADJUSTMENTS
WARNING
!
1.
_
Attach one wheel to one side of the
lower leg using the hex bolt (1), the two at washers
(2), the sleeve (3) and the nut (4), as shown in Fig. A.
NOTE: Verify that the side of the wheel that has
more ribs (5) is facing toward the stand.
2. Tighten using two 17 mm wrenches.
3. Spin the wheel to make sure it moves properly.
4. Repeat the above steps for assembling the other
wheel to another side of the lower leg.
5.
_
Attach the long stand leg tube (1)
into the curved stand leg using the bolt (2) and the
nut (3) as shown in Fig. A-1.
NOTE: This is the leg tube with the welded nut on
the bend area of the leg tube.
6. Tighten with a phillips screwdriver and 10 mm
wrench.
7. Repeat steps 5-6 for assembling the other stand leg
tube (4) into the straight stand leg.
8. Assemble the foot pad (5) with the bolt (6) and
nut (7) in the other stand leg tube (4).
9. Assemble the adjustable foot pad (8) with the wing
nut (9) and thread onto the welded nut.
NOTE: This adjustable foot pad is used to level the
saw. Loosen the wing nut (9), turn the adjustable foot
pad (8) clockwise to raise and counterclockwise to
lower the stand, then tighten the wing nut (9).
(Fig. A-2)
10. - Attach one stand handle (NOTE: Both
handles are the same) to one side of the stand using
the bolt (1) and nut (2) as shown in Fig. A-3. Tighten
with a phillips screwdriver and 10 mm wrench.
Repeat step for assembling the other stand handle.
11.Insert the screw (3) into the hole (4) on both handles
and tighten with a phillips screwdriver.
2
5
4
3
1
6
7
8
9
1
3
2
4
Raise the Stand Lower the Stand
4
2
1
3
5
2