Use and Care Guide

ManualsBrandsPORTER-CABLE ManualsTable SawsPCB222TS



USING THE WOOD FACING ON THE MITER GAUGE

(FIG. XX)

Slots are provided in the miter gauge for attaching an

auxiliary facing (1) to make it easier to cut very long or

short pieces. Select a suitable piece of smooth wood,

drill two holes through it and attach it to the miter gauge

with screws. Make sure the facing does not interfere

with the proper operation of the saw blade guard. When

cutting long workpieces, you can make a simple outfeed

support by clamping a piece of plywood to a sawhorse.



BEVEL CROSSCUTTING (FIG. YY)

0°~45° BLADE BEVEL & 90° MITER ANGLE. This

cutting operation is the same as crosscutting except the

blade is at a bevel angle other than 0°.











1. Lower the blade to the down position.

2. Adjust the blade (1) to the desired angle, and tighten

the blade bevel lock handle.

3. Tighten the miter lock handle (2) at 90°.

4. Hold workpiece (3) rmly against the face of the miter

gauge throughout the cutting operation.



COMPOUND MITER CROSSCUTTING (FIG. ZZ)

0°~45° BLADE BEVEL & 0°~45° MITER ANGLE











1. Set the miter gauge (3) to the desired angle.

2. Place the miter gauge in the right side groove of

the table.

3. Set the blade (1) bevel to the desired bevel angle

and tighten the blade bevel lock handle.

4. Hold workpiece (2) rmly against the face of the miter

gauge throughout the cutting operation.



MITERING (FIG. aa)

0°~45° MITER ANGLE

This sawing operation is the same as crosscutting

except the miter gauge is locked at an angle other

than 90°.

1. Set the blade (1) to 0° bevel angle and tighten the blade

bevel lock handle.

2. Set the miter gauge (3) at the desired miter angle

and lock in position by tightening the miter gauge

locking handle.

3. Hold the workpiece (2) rmly against the face of the

miter gauge throughout the cutting operation.

WARNING