User Guide

9
Operating Instructions
Installing and Removing the Battery Pack From the Tool
CAUTION: Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery pack firmly into tool until an
audible click is heard as shown in Figure B. Ensure battery pack is fully seated and
fully latched into position.
TO REMOVE BATTERY PACK: Depress the battery release button (C1) as
shown in Figure C and pull battery pack out of tool.
Trigger Switch & Forward/Reverse Button - Figure D
• ThedrillisturnedONandOFFbypullingandreleasingthetriggerswitch(1)shown
in Figure D. The farther the trigger is depressed, the higher the speed of the drill.
• Aforward/reversecontrolbutton(2)determinestherotationaldirectionofthetooland
also serves as a lock off button.
• Toselectforwardrotation,releasethetriggerswitchanddepresstheforward/reverse
control button on the right side of the tool.
• Toselectreverse,depresstheforward/reversecontrolbuttonontheleftsideofthe
tool.
• Thecenterpositionofthecontrolbuttonlocksthetoolintheoffposition.When
changing the position of the control button, be sure the trigger is released.
Adjusting Torque Control - Figure E
This tool is fitted with a torque adjustment collar (3) to select the operating mode and to
set the torque for tightening screws. Large screws and hard workpiece materials require
a higher torque setting than small screws and soft workpiece materials.
• For drilling in wood, metal and plastics, set the collar to the drilling position symbol
• Forscrewdriving,setthecollartothedesiredsetting.Ifyoudonotyetknowthe
appropriate setting, proceed as follows:
• Setthecollartothelowesttorquesetting.
• Tightenthefirstscrew.
• Iftheclutchratchetsbeforethedesiredresultisachieved,increasethecollarsetting
and continue tightening the screw. Repeat until you reach the correct setting. Use
this setting for the remaining screws.
Dual Range Switch - Figure F
The dual range feature of your drill allows you to shift gears for greater versatility.
• Toselectlowspeed,hightorquesetting(position1),turntooloffandpermittostop.
Slide gear shifter button (4) away from the chuck.
• Toselectthehighspeed,lowtorquesetting(position2),turntooloffandpermitto
stop. Slide gear shifter button back toward the chuck.
NOTE: Do not change gears when tool is running. If you are having trouble changing
gears, make sure that the dual range gear button is either completely pushed
forward or completely pushed back.
Keyless Chuck - Figure G
WARNING: Make certain the battery pack is removed to prevent tool actuation
before installing or removing accessories.
To insert a drill bit or other accessory:
1. Grasp the chuck (5) and rotate it in the counterclockwise direction, as viewed from
the chuck end.
2. Insert the bit or other accessory fully into the chuck, and tighten securely by
rotating the chuck in the clockwise direction as viewed from the chuck end.
WARNING: Do not attempt to tighten or loosen drill bits (or any other accessory)
by gripping the front part of the chuck and turning the tool on. Damage to the chuck
and personal injury may occur when changing accessories.