Use and Care Manual

9 - ENG

2. If the depth adjustment ring (B) is not on the motor,

FIG. 3

thread the depth adjustment ring (B) onto the

motor until the ring is positioned as shown. Insert

the motor into the base by aligning the groove in

the back of the motor with the guide pins (L) on the

base. Slide the motor down until the depth

adjustment ring (B) snaps into place.

3. Adjust the depth of cut by turning the depth

adjustment ring (B). Refer to Adjusting the Depth

of Cut.

4. Close the locking lever (H) when the desired depth

is achieved. For information on setting the cutting

depth, Refer to Adjusting the Depth of Cut.

MOTOR QUICK RELEASE (FIG. 3)

1. Open the locking lever (H) on the base.

2. Grasp the base with one hand, depressing both

quick release tabs (A).

3. With the other hand, grasp and pull motor from the

base.

BIT INSTALLATION AND REMOVAL (FIG. 4)

SELECTING THE BIT

WARNING

Projectile hazard. Only use bits with 1/4" (6.4 mm) shanks. Smaller

shank bits will not be secure and could become loose during operation.

These laminate trimmers are equipped with a 1/4" (6.4mm) diameter collet which accepts

bits having 1/4" (6.4mm) diameter shanks. Bits are available as an accessory.

WARNING

Do not use bits with a diameter in excess of 1" (25.4mm) in

this tool.

FIG. 4

INSTALLING THE BIT

NOTE: The bit shank and chuck should be clean and free of dust, wood residue and

grease before assembling.

1. Remove the motor unit from the base. Refer to Motor Quick Release (if needed).

2. Clean and insert the bit shank into the collet until the end of the shank bottoms.

Then withdraw the bit approximately 1/16" (1.6mm).

3. Press and hold the spindle lock button (D). Tighten the collet nut securely with the

supplied17 mm open-end wrench (T).

NOTE: As an alternative to the spindle lock button, a thin 10 mm wrench can be

used on the flats of the spindle (F).

To remove the bit, reverse the procedure. If the bit will not remove easily, lightly tap

the bit shank with a wrench.