Use and Care Guide

9
Combination square
Feeler gauge
(size 0.02 in.)
Phillips screwdriver
Supplied Not Supplied
2 mm hex wrench
4 mm hex wrench Adjustable wrench
Open end wrench
TOOLS NEEDED FOR
ASSEMBLY
UNPACKING AND CHECKING CONTENTS
Carefully unpack the band saw and all its
parts, and compare against the list below and
the illustration on the next page. With the help
of an assistant place the saw on a secure
surface and examine it carefully.
● To avoid injury from unexpected starting
or electrical shock, do not plug the
power cord into a source of power during
unpacking and assembly. This cord must
remain unplugged whenever you are
adjusting/assembling the saw.
● The saw is heavy and should be lifted
with care. If needed, get the assistance of
someone to lift and move the saw.
● If any part is missing or damaged, do not
attempt to assemble the band saw, or
plug in the power cord until the missing or
damaged part is correctly replaced.
TABLE OF LOOSE PARTS
ITEM DESCRIPTION QUANTITY
A.
Band saw
1
B.
Miter gauge
1
C.
Table locking knob and washer
1 each
D.
Band saw table assembly
1
E.
Open end wrench
1
2 mm hex wrench
1
4 mm hex wrench
1
CARTON CONTENTS
WARNING
!