Use and Care Guide

15
6. Install the rack ring (6) onto the column,
so the top lip of the rack sits into the rack
ring (6). (Fig. E)
NOTE:
To avoid column or collar damage,
DO NOT OVERTIGHTEN the set screw (7).
The bottom of the collar MUST NOT be
pushed all the way down onto the top of
the rack. MAKE SURE the top of the rack
is under the bottom of the collar and that
there is enough clearance to allow the
rack to freely rotate around the column.
Tighten the set screw (7) using the 3 mm
hex wrench.
Fig. E
7. Install the table crank handle (8) onto the
worm gear shaft (9) on the side of the
table bracket. (Fig. F)
8. Line up the at side of the shaft with the
set screw (10) in the crank handle and
tighten the screw with the 3 mm hex
wrench provided. Do not overtighten.
Fig. F
INSTALLING THE HEAD (FIG. G)
The Drill Press head is very heavy and
MUST be lifted with the help of 2 people
OR MORE to safely assemble the Drill
Press head on the column.
1. Carefully lift the head (1) and slide it onto
the column (2). Make sure the head (1)
slides down over the column as far as
possible. Align the head with the base.
2. Tighten the two head locking set screws (3)
on the right side of the head by using the
provided 4 mm hex wrench.
Fig. G
INSTALLING FEED HANDLES (FIG. H)
1. Bag “D” - Locate the three feed
handles (1) in the loose parts bag.
2. Thread each feed handle (1) into the
threaded holes (2) on the hub assembly (3)
and tighten.
Fig. H
INSTALLING THE CHUCK (FIG. I, J)
Before any assembly of the chuck and
arbor to the drill press head, clean all
mating surfaces with a non petroleum
based product; such as alcohol or lacquer
thinner. Any oil or grease used in the
packing of these parts must be removed
otherwise the chuck may come loose
during operation.
WARNING
!
WARNING
!
6
5
7
10
8
9
3
2
1
1
2
3
WARNING
!