User's Manual

ASSEMBLING AND ADJUSTING BASE AND ROLLER GUIDE

Remove power unit from base unit (see “TO INSTALL BIT”), and install the bit.

The base and roller guide (A) Fig. 4, is assembled at the factory. To

assemble, remove a sub-base mounting screw (A) Fig. 5 and insert alignment pin

in guide base into hole (C) in bottom of trimmer sub-base. Fasten with two

mounting screws (F) Fig. 4, as shown in Fig. 5A. Do not tighten at this time.

3. Install proper bit as outlined under “TO INSTALL BIT.” Then, install motor to

base and adjust depth of cut (see “ADJUSTING DEPTH OF CUT”).

4. Align roller guide with bit by loosening locking screw (Fig. 5A) and turning

adjusting screw, with hex wrench provided, until guide is in desired location.

NOTE: Guide mounting holes are oversized allowing guide to be

rotated on alignment pin to align guide roller with bit.

5. For making flush cuts align roller guide with straight portion of bit. For

bevel cuts, adjust cutting depth so that only the bevel portion of bit projects

through trimmer base and adjust roller guide to produce desired amount of

bevel.

6. Tighten all screws and make a trial cut on scrap material to check

alignment. Readjust if necessary.

FLUSH TRIMMING

1. DISCONNECT TOOL FROM POWER SOURCE.

2. Attach base and guide to trimmer as outlined under ASSEMBLING AND

ADJUSTING BASE AND ROLLER.

3. Remove roller guide and replace with flush trimming guide (B) Fig. 4.

This guide may be identified by the molded on letter “F”. The stud on the end

of this guide must face toward the trimmer base.

4. Install guide setting gauge (E) Fig. 4, into trimmer collet (see TO INSTALL

BIT). Install trimmer motor to base. Adjust guide so that hole in end of gauge

may be positioned over the guide stud.

Fig. 4

ABCD EFG

ADJUSTING

SCREW

LOCKING SCREW

MOUNTING

SCREW

Fig. 5A

Fig. 5