Use and Care Guide

6
6. Insert bulbs (not included). Use 40-watt max. candelabra-base
(E12) incandescent bulbs. Then, attach the cover (D) to the
fixture (E) with thumbscrews (GG).
7. Connect bare ground wire from the base (C) to the ground
wire from the concrete by twisting a wire nut (EE) onto bare
ends of the wires. Connect white wire from the base (C) to the
white wire from the concrete by twisting a wire nut (EE) onto
bare ends of the wires. Connect the black wire from the base
(C) to the black wire from the concrete by twisting a second
wire nut (EE) onto
the bare ends of the wires.
Secure the wire
nuts (EE) with electrical tape (not included).
8. With the help of another person, place the assembly over the
mounting bracket (AA) and anchor bolts (BB). Secure with
the cap nuts (CC) and washers (DD).
CARE AND MAINTENANCE
To clean, unplug lamp and wipe with a damp, non-abrasive cloth.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
The light will not go on.
1. No power.
2. Fixture may be wired
incorrectly.
3. Switch may be wired
incorrectly.
1. Make sure lamp fixture is
plugged in and power is on.
2. Check wiring.
3. Check wiring.
Fuse blows or circuit trips
when fixture is turned on.
Crossed wires or power wire is
grounding out.
Consult a certified electrician.
Hardware Used
Wire Nut x 3
EE
EE
Hardware Used
Cap nut x 3
Washer x 3
CC
8
DD
CC
DD
Hardware Used
Thumbscrew x 2
GG
6
E
GG
D
7