Installation Guide

SAFETY INFORMATION

WARNING

• Before assembling your lighting fixture, refer to the caution titled ELECTRICAL CONNECTIONS.

If you feel you do not have enough electrical wiring experience, refer to a do-it yourself wiring

handbook or have your fixture installed by a qualified licensed electrician.

• Before starting the installation, disconnect the power by turning off the circuit breaker or by

removing the fuse at the fuse box. Turning the power off to the light switch is not sufficient to

prevent electrical shock.

CAUTION

• To ensure the success of the installation, be sure to read these instructions and review the

diagrams thoroughly before beginning.

• All electrical connections must be in accordance with local codes, ordinances, or the National

Electrical Code.

• These fixtures are intended to be mounted to an outlet junction box. The box must be directly

supported by the building structure.

• Refer to the relamping label located near the lamp holder for the recommended maximum

wattage -- do not exceed recommended wattage.

• ELECTRICAL CONNECTIONS (Required Supply Circuit: 120V, 60Hz)

Connect the white wire(s) from the fixture to the white wire of the supply circuit. Connect the

black wire(s) from the fixture to the black wire of the supply circuit. Connect the green (or bare

copper) colored wire to the grounding conductor of the supply circuit. Use U.L./CSA Listed wire

connectors suitable for the size, type and number of conductors. No loose strands or loose

connections should be present. Secure wire connectors with U.L./CSA Listed electrical tape.

Before beginning assembly of product, make sure all parts are present. Compare parts with

package contents list and diagram above. If any part is missing or damaged, do not attempt to

assemble the product. Contact customer service.

Estimated Assembly Time: 30~60 minutes

Tools Required for Assembly (not included): Ladder, Phillips Screwdriver,

Flathead Screwdriver, Wire Cutter, Pliers, Saftey Glasses and Electrical Tape

Helpful Tools (not included): Wire Stripper

PREPARATION

HARDWARE CONTENTS (shown actual size)

Wire

Connector

Qty. 3

BBAA

Junction

Box Screw

Qty. 2

Suction Cup

Qty. 1