Use & Care Guide

ASSEMBLY INSTRUCTIONS

1. Strip 3/4 in. of insulation from wire ends of fixture

(A) and of supply circuit wires. Holding fixture (A),

attach ground supply circuit wire and ground fixture

wire together with wire nut (DD). (Alternatively, if

there is no ground supply circuit wire, only attach

the ground fixture wire to the mounting bracket (EE)

with the green screw (CC). Never connect ground

wire to black or white power supply wires). Then

twist stripped wire ends of fixture (A) and supply

circuit wires together, black to black (hot) and white

to white (neutral). Twist on wire nuts (DD). Tape

wire nuts (DD) and wires together. Carefully tuck

connected wires and wire nuts (DD) into outlet box

(not included). Attach the mounting screws (AA) to

the mounting bracket (EE). Fasten mounting

bracket (EE) onto the outlet box using two outlet

box screws (BB).

2. Screw threaded nipple (FF) onto the nipple

holder of fixture (A) to the maximum position. Place

the fixture (A) over the mounting bracket (EE). Both

ends of the mounting screws (AA) are to come out

through fixture (A). Tighten decorative nuts (JJ) onto

mounting screws (AA).

Hardware Used

x 3

Wire Nut

Mounting

Bracket

x 1

x 2

x 1

x 2

Mounting Screw

Outlet Box Screw

Green Screw

Hardware Used

x 2

Mounting Screw

x 2

Decorative Nuts

Lowes.com/portfolio