Use & Care Guide

6
CARE AND MAINTENANCE
• Clean with soft dry cloth. Do not use abrasives.
• Shut off main power supply before replacing bulbs.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
1. Bulb is burned out. 1. Replace light bulbs.
2. Power is off. 2. Check if power supply is on.
3. Faulty wire connection 3. Check wiring.
4. Faulty wall on/off switch 4. Test or replace wall on/off switch.
Bulb won’t light.
ASSEMBLY INSTRUCTIONS
Hardware Used
x 1
Cap
I I
Knob
x 1
NN
x 1
x 1
x 1
Threaded nipple
Nut
Rubber Ring
HH
FF
GG
Washer
x 1
MM
3
A
FF
GG
KK
Inner Cap
x 1
KK
Large Rubber Ring
x 1
LL
3. Attach inner cap (KK) on threaded nipple (FF) and
tighten with nut (GG). Install 60-watt max.
medium-base bulbs (not included). Use only bulbs of
the specified type and maximum rated wattage or
less.
4. Place large rubber ring (LL) over inner cap (KK),
followed by the glass shade (B), small rubber ring
(HH), washer (II) and tighten onto the threaded
nipple (FF) with nut (GG). Then place the cap (NN)
onto the threaded nipple (FF) and tighten with the
knob (MM).
x 1
Nut
GG
Hardware Used
4
A
LL
HH
I I
NN
B
MM
FF
GG
KK
Lowes.com/portfolio