Installation Guide

ASSEMBLY INSTRUCTIONS
4
1. Insert long machine screws (CC) into the
mounting bracket (EE) before connecting
to the outlet box. The long machine screws (CC)
should protrude through mounting bracket (EE)
for securing canopy (A) in later steps. Connect the
mounting bracket (EE) to the outlet box with short
machine screws (BB). Orient the mounting
bracket (EE) so that the raised center portion
protrudes into the outlet box. (See Fig. 1.)
Short Machine
Screws
x 2
x 2
x 1
BB
EE
Mounting
Bracket
Hardware Used
Long Machine
Screws
CC
Hardware Used
x 1
EE
Mounting
Bracket
Ground
Screw
FF
2. Ground wire connection guide (See Fig. 2.):
• For installation in the United States:
Wrap ground wire from outlet box around
ground screw (FF) on mounting bracket (EE),
no less than 2 in. from wire end. Tighten
ground screw (FF). If fixture is supplied with
a ground wire, connect to outlet ground wire
with an extra wire connector (AA).
• For installation in Canada:
If fixture is supplied with ground wire, wrap
ground wire around ground screw (FF) on
mounting bracket (EE). Tighten ground
screw (FF).
x 1
Wire Connector
AA
CC
Outlet Box
(Not Included)
EE
BB
1
2
GND
EE
FF
GND
AA