Installation Guide

ManualsBrandsPortfolio ManualsChandeliersFD15-094-1

ITEM #0759872

0759874

MODEL #FD15-094

FD15-094-1

3-LIGHT CHANDELIER

Lowes.com/portfolio

EB15626

ATTACH YOUR RECEIPT HERE

Questions, problems, missing parts? Before returning to your retailer, call our customer

service department at 1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. -

5 p.m., EST, Friday.

Serial Number

Purchase Date

Español p. 18

Français p. 9

Summary of content (5 pages)

PAGE 1
ITEM #0759872 0759874 3-LIGHT CHANDELIER MODEL #FD15-094 FD15-094-1 Français p. 9 Español p. 18 ATTACH YOUR RECEIPT HERE Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. 5 p.m., EST, Friday. EB15626 Lowes.
PAGE 2
PACKAGE CONTENTS HARDWARE CONTENTS (shown actual size) B AA B BB B CC B DD B EE B FF B GG Ring Wire Nut BA Qty. 3 BB Mounting Screw Qty. 2 BE Crossbar (not shown to size) Qty. 1 Screw Collar Loop (preassembled to Crossbar (CC)) (not shown to size) (preassembled to Chain Crossbar (preassembled (CC)) to Crossbar (CC)) Qty. 1 (not shown to size) Canopy (not shown to size) Qty. 1 Qty. 1 Qty.
PAGE 3
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS 1. Remove chain (FF), ring (EE) and screw collar loop (DD) from preassembled threaded nipple on crossbar (CC). Then, attach crossbar (CC) to outlet box (not included) using mounting screws (BB). Note: The threaded nipple should protrude outward. 3. Pull out the supply wires and supply ground wire from the outlet box. Strip 3/4 in. of insulation from wire ends.
PAGE 4
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS 6. Tighten ring (EE) onto screw collar loop (DD) to secure canopy (GG) over crossbar (CC). Open the bottom section of the chain (FF) and attach it to the flying ring preassembled on pole (A). Hardware Used 9. Remove hex nut (J) from the threaded nipple (I). Note: The assistance of another person is recommended to hold up fixture (C) during this step.
PAGE 5
CARE AND MAINTENANCE • Shut off main power supply before wiping product with damp cloth or window cleaner. Do not use abrasives. TROUBLESHOOTING PROBLEM Bulb won’t light. Fuse blows or circuit breaker trips when light is turned on. POSSIBLE CAUSE 1. Bulb is burned out. 2. Power is off. 3. Faulty wire connection. 4. Faulty switch. Crossed wires or power wire is grounding out. CORRECTIVE ACTION 1. Replace light bulb. 2. Make sure power supply is on. 3. Check wiring. 4. Test or replace switch.