Installation Guide

ManualsBrandsPortfolio ManualsLighting & Fans9-in W Brushed Nickel Ceiling Flush Mount

Questions, problems, missing parts? Contact the customer service department at

1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday.

ITEM #0292381, 0156935

MODEL #GL2301-WHES-I, GL2301-NKES-I

FLUORESCENT

CEILING FIXTURE

Portfolio™ is a registered trademark of LF, LLC. All

Rights Reserved.

Français p. 7

Español p. 13

Summary of content (6 pages)

PAGE 1
ITEM #0292381, 0156935 FLUORESCENT CEILING FIXTURE MODEL #GL2301-WHES-I, GL2301-NKES-I Portfolio™ is a registered trademark of LF, LLC. All Rights Reserved. Français p. 7 Español p. 13 Questions, problems, missing parts? Contact the customer service department at 1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday.
PAGE 2
PACKAGE CONTENTS A C C E B D Part A B C Description Quantity Fixture Pan 1 Bulb Socket 1 Diffuser Thumb Screw 1 (preassembled to Fixture Pan (A)) Part D E Description Diffuser Bulb Quantity 1 1 HARDWARE CONTENTS AA BB Wire Nut 1-1/2 in. Machine Screw Qty. 3 Qty. 2 WARNINGS AND CAUTIONS WARNING • Shut off power at the circuit breaker or fuse panel before removing the old fixture or installing the new one. CAUTION • DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
PAGE 3
ASSEMBLY INSTRUCTIONS With power disconnected to your electrical box, remove the old fixture. If your old fixture is attached to an electrical box having more than two (2) wire leads, we suggest you use tape and markings to keep track of which wires were attached to each other. 1. Screw 1-1/2 in. machine screws (BB) into the electrical 1 box until there is about 1-1/4 in. between the ceiling and the underside of the screw head (Fig. 1). Hardware Used 1-1/2 in. BB Machine Screw 1-1/4 in. x2 BB BB BB 2.
PAGE 4
ASSEMBLY INSTRUCTIONS 4. Connect the supply leads from the electrical box to the fixture wire leads using the wire nuts (AA) (Fig. 4). The black lead from the fixture pan (A) is spliced to the black supply lead, and the white lead from the fixture pan (A) is spliced to the white supply lead. Make sure the wire nuts (AA) are tight. You can wrap electrical tape around the wire nuts (AA) to prevent them from coming loose. Carefully push the spliced wires back into the electrical box.
PAGE 5
BULB REPLACEMENT INSTRUCTIONS This fixture uses one (1) GU24 23W self-ballasted fluorescent bulb. These bulbs are readily available at your local home center, and most larger hardware stores. Before replacing bulb (E), shut off power to the fixture at the circuit breaker, or fuse panel. Allow sufficient time for fixture and lamp to cool. 1.
PAGE 6
TROUBLESHOOTING Minor problems often can be fixed without the help of an electrician. Before doing any work on the fixture, shut off power supply at the circuit breaker panel to avoid electrical shock. Problem Possible Cause Corrective Action Fixture doesn’t light. Circuit breaker trips when light is turned on. 1. Power is off. 2. Bad wire connection. 3. Defective bulb(s). 4. Defective wall switch. 1. Crossed wires or power wire is grounded out. 1. Check circuit breaker or wall switch. 2.