Installation Guide

ManualsBrandsPortfolio ManualsLighting & FansWhite Ceiling Fluorescent Light ENERGY STAR (Common: 2-Ft; Actual: 26.5-in)

Remove both finial caps (BB) by unscrewing

counterclockwise. Remove the diffuser (C) to expose the

bulbs.

BULB REPLACEMENT INSTRUCTIONS

You may want to periodically clean the fixture using a mild, non-abrasive soap based cleaner and

soft cotton cloth. Do NOT use solvents, cleaners containing abrasive agents, ammonia, or

surfactants. When cleaning the fixture, make sure you have the power turned off and do not spray

liquid cleaner directly onto the diffuser, bulb, socket, ballast, or wiring.

CARE AND MAINTENANCE

When bulb replacement is necessary, you must replace the bulb with a 17-watt, 120-volt/F17T8 fluorescent

bulb. These bulbs are readily available at your local home center and most larger hardware stores.

Before replacing the bulb(s), shut off power to the fixture at the circuit breaker or fuse panel. Allow

sufficient time for fixture and lamp to cool.

3. Install the new bulb in the same manner you removed

the old bulb.

Re-install the diffuser (C) and finial caps (BB). Restore power to the fixture.

4. Dispose of the old bulb(s) in accordance with local, state, and/or federal laws, or go to

www.epa.gov/cflcleanup for more information.

2. Remove the defective bulb by

using your thumbs to

press and roll the bulb 90 degrees inside the

socket

(B)

. This will disengage the bulb contact pins from

the socket

(B)

contacts. Then slide the bulb pins out of the

socket

(B)

slot.

Minor problems often can be fixed without the help of an electrician. Before doing any work on the

fixture, shut off power supply at the circuit breaker panel to avoid electrical shock.

TROUBLESHOOTING

Fixture doesn’t light.

Circuit breaker trips

when light is turned on.

1. Power is off.

2. Bad wire connection.

3. Defective bulb(s).

4. Defective wall switch.

1. Crossed wires or power wire

is grounded out.

1. Check circuit breaker or wall switch.

2. Check wire splices.

3. Replace bulb(s).

4. Replace switch.

1. Check wiring connections.

In the unlikely event that your fixture’s ballast or lamp socket(s) fail, they can be replaced by a

qualified electrician. For further information regarding these replaceable parts, please have your

electrician contact our technical support number at 1-800-643-0067.

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION