Installation Guide

6. Install bulbs (not included). Use two 60-watt
max. candelabra-base bulbs only.
6
C
Outlet Box
Bulb
B
6
5
ASSEMBLY INSTRUCTIONS
5. Carefully tuck all wires into the outlet box and
position the backplate of the fixture body (B)
over the outlet box. Align the holes in the
backplate of the fixture body (B) with the
mounting screws attached to the crossbar (C).
Pass the fixture over the mounting screws and
secure by threading mounting balls onto end of
mounting screws. Tighten until snug.
7
7. To prevent moisture from entering the wire
compartment, apply a small amount of silicone
sealer (not included) to the threaded side of the
mounting balls and then install them onto the
mounting screws. Wipe off excess caulk.
Silicone Sealer
Lowes.com/portfolio
Mounting Screw
Mounting Ball
Mounting Ball