Use and Care Guide

ITEM #0128058
3 in 1 SOLAR BALL LIGHT
PARTS
A - Ball (Light) B - Base
C - Stake D - Anchor point
(Refer to Fig. 1)
Fig. 1
Fig. 2
Fig. 3
READ ALL INSTRUCTIONS COMPLETELY
BEFORE USE. SAVE INSTRUCTIONS FOR
FUTURE USE.
MODEL #SPFL-1M
The ON/OFF switch, located on the bottom of the ball, has 2
settings--one for ON and one for OFF. The ON/OFF switch
will be pre-set in the OFF position when ball (light) is
brand new.
(Fig. 3)
WAYS TO USE
1. Ball (light) may be placed on a table or any flat surface by
using the black base provided. The anchor point may be used
to keep light fixed in the base.
2. Ball (light) may be placed in the dirt, grass or any other soft
surface by using the stake provided.
3. Ball (light) may be placed directly in a pond or pool. The
anchor point may be used, along with a string, to keep ball
(light) from moving too far in the water.
(Refer to Fig. 2 for “Ways to Use”)
1
ON/OFF
switch
dirt / grass
pool / pond
string
B
B
A
A
A
A
A
D
D C
C
IMPORTANT: Batteries in the solar ball light will need to
charge for 24 hours when using for the first time. Place
solar ball light in an area that will allow it to receive FULL
SUN in order for rechargeable batteries to reach
maximum charge.
*PLEASE NOTE: The ON/OFF switch must be in the OFF
position for the batteries to charge the first time.
D