Installation Guide

Remove decorative nuts (D) from preassembled

fixture screws on mounting plate (B). Unwrap

BARE wire from BLACK and WHITE wires on back

side of mounting plate (B), and then remove

mounting plate (B) from fixture (A). Gently pull on

BARE wire from inside of mounting plate (B) until

wire comes completely through small metal hole to

which BARE wire is attached.

Lowes.com/

ortfolio

ASSEMBLY INSTRUCTIONS

Fixture

Screws

Feed wires through bushing on mounting plate (B).

Attach mounting plate (B) to outlet box (not

included) using the existing washers and outlet box

screws or the machine screws (BB). Note: If the

outlet box screws required for your outlet box are of

a different size than the machine screws (BB),

consult with a licensed electrician before

proceeding.

Use a level (not included) to adjust mounting plate

(B) parallel with floor and ceiling as needed, then

tighten machine screws (BB) completely to secure

mounting plate (B).

CAUTION: Make sure the outlet box can

support 35 lbs. hanging weight. Use metal outlet

box; plastic outlet boxes are not recommended.

Outlet Box

Hardware Used

Machine Screw

x 2

Washer

Bushing