User's Manual

mode, the first 30 seconds countdown, The horn will sound once and parking lights will flash once

every 10 seconds, after 30 seconds, horn will sound once and parking lights will flash once every 5

seconds, 30 seconds later, horn will sound and parking lights will flash once every 1 second. 60

seconds later, engine will not be able to start again (if starter cut relay connected).

4. Emergency release: (can be performed at any time) If Server send Emergency release command while

at Arming mode, panic mode, anti-car jacking mode. Then system will exit ‘Arming’ ‘Anti-carjacking’

‘Panic’ mode. The ‘Arming’, ‘parking light’ and ‘horn’ outputs will back to normal (Disarm) status.

1.7 IRKP-20

External wireless 20- key keypad to used for calling

1.8 Valet switch operation

User can use the supplied Valet switch to perform 7 essential tasks, including (1) sending help report (2)

activate or deactivate Immediate Geofence (3) Activate panic mode (4) sending ‘Duty on’ or ‘Duty off’

report to the server (5) Emergency release to exit ‘ARM’, ‘Anti-carjacking’ or ‘Panic’ modes (6) code

learning for build in alarm, (7) set valet mode for build in alarm

1.9 handset operation

(Optional)

User can use the supplied handset (HS200) to perform the function such as send/receive SMS, phone in/out,

main unit status display etc. For detail, refer to the user manual of HS200.

1.10 History report

Flash memory for recording reports up to 6000 reports. It can be read out from the PC setup program via

serial port.

1.11 Internal battery

The system has a built-in rechargeable battery (4.8V 80mA/H) for emergency use. The system will send a

power cut report when all the external power are disconnected.

1.12 LED indication

Three LED indicate the status of the POWER, GPRS signal and GPS signal.

1.13 Keep alive procedure

Keep alive procedure (in order keep connection in GPRS network, the unit can be set to send short keep

alive report to the server in order to prevent the disconnection from the mobile service provider)

1.14 Sleep Mode

The Sleep Mode:

For long periods of inactivity user have the options to set the unit in sleep mode this will enable the unit to

save electric power.

GT3200ST Can go to sleep mode when ACC goes off, Shock-sensor not be trigger for 5minuts and this

feature is configurable. “GPS” can be power off. User can setup the automatically wakeup time during the

sleep mode to ensure the device is working. The system can send out a diagnostic report to the server after

waking up.