User's Manual

In Commercial Confidence
2
In addition, the system has a built-in rechargeable battery (12V 1.2A/H) for emergency use. The system will
send an emergency “power cut” report when all of the external power is removed. User can check the external
battery capacity status from the server. There system has another important security function-GPS Antenna
Presence Detection. The system will send an emergency “GPS antenna failed” report when the GPS antenna is
removed
Waterproof casing design
II. BASIC FUNCTIONS
FUNCTIONS APPLICATIONS
GPS
GPS receiver will output a complete position, velocity, and time (PVT) solution in
the NMEA Version 3.0 protocol
GPRS, SMS
GPRS use standard TCP or UDP communicate protocol. If the GPRS service is failed,
the SMS mode will be turned on for emergency use.
5 Input
1. In-vehicle ACC
2. 2 general input port
3. Valet Switch+LED
4. Tamper Switch
5. Built-in 3-D acceleration sensor
2 Output
1.Built-in cut relay NO output
2. Siren
2 Button Valet Switch
with 1 LED indicator
1. Activate Self-Geofence (press button1 once.) Deactivate Self-Geofence (press
button1 once.)
2. Help request report (press button1 for 2 seconds.)
3. Panic report (press button 2 once).
4. Emergency-release. (Press button1+2 three times when ACC ON)
5. Intelligent power saving and control. (Press button1+2 for 5 sec.)
PC-setup
Initialize the unit and program the device, including Network APN, server IP address,
user message, report control, and Geofence setting, etc …
Note that Network APN and server IP details must be set before the installation.
Standard Report
Automatic report for AVL tracking purpose:
Fixed time report
Fixed distance report
Intelligent report (combine time and distance)
Event Report
Speeding report
Low battery report
Geofence trigger report
ACC on/off
Unit box is open/closed
GPS antenna disconnect
A/D input trigger, e.g. air bag deploy
Acceleration sensor trigger…………
History data store 900 reports can be saved in unit, and can be read from server and pc-setup