User's Manual

23
d. Voltage input: in voltage mode the unit detects the voltage is drop 1.0V for more
than 5 consecutively seconds during ‘RUN’ time (if voltage detect mode).
e. Unsuccessful start attempts: Three consecutively unsuccessful start attempts.
TIMER START MODE OPERATION
a. Timer mode activation: Anytime, press and hold button 3+4 together for 2 seconds
on T36 or press button 5 once then press button 4 once within 3 seconds on T35.
b. The parking lights will flash 4 times as confirmation of activating ‘Timer mode’.
c. Timer mode start interval: The operator has the option to have the unit start every 12
or 1or 3 or 6 hours. Factory default is 12 Hour intervals. To select 12 or 1or 3 or 6
hour automatic start timer in feature programmable.
d. When timer modes start successful, the two-way transmitter LCD screen will display
the “time”. NOTE1: This feature cannot be activated when the ignition is ON or the
unit is in the ‘RUN’ mode.
NOTE2: 3 Unsuccessful starts attempts will count as 1 successful start. The unit will
attempt to start again at the next Timer mode start interval.
EXIT TIMER MODE: The following inputs & operations will cause the unit to exit the
‘TIMER’ mode.
a. Press and hold button 3+4 together for 2 seconds on T36 or press button 5 once then
press button 4 once within 3 seconds on T35.
b. (+) Input on the foot brake input wire
c. (-) Input on the hand brake input wire
d. (-) Input on the hood pin wire
e. The ignition is ON while the unit is NOT in the ‘RUN’ mode.
f. The unit has called the Remote Start activation option additional times.
g. ‘RUN’ mode is exited due to RPM signal 8 times programmed value (if RPM detect
mode).
DIAGNOSTICS MODE
When the engine stop running. Than the parking light will flash “N” times indicate the
reason for shutdown.
The indications are as follows:
1Flash 10(5, 20, 30) min run timer expired or transmitter activation input.
2Flashes Low or No RPM signal received.