User's Manual

PANIC

1. Press button 1+2 at the same time, lamp will flash and siren will sound for 10 sec.

2. Press any button to stop sounding.

ANTI MOTORCYCLE-JACKING

1. When key has been turned ON, press button 2, then motorcycle-jacking mode is activated. Siren will chirp once every 3sec., after

chirping 5 times, siren will chirp once every 1.5sec. After chirping 8 times, lamp will flash and siren will sound for 10 sec. Then lamp

will continue flashing and siren will continue sounding and disable the engine. During anti motorcycle-jacking mode, when the key

turns to OFF, siren will stop and engine will be disabled. If key has been turned to ON again, siren will sound and engine will not be

able to start. LED will flash quickly.

2. To exit anti motorcycle-jacking : Turn key to ON, and press button 2 for 2 sec.

SHOCK SENSOR

In arming mode, if motorcycle is knocked lightly, siren will chirp twice and lamp will flash twice for warning (chirp 1 sec. and stop 1 sec.), if

motorcycle is shocked heavily, siren will chirp 10 sec.,

EMERGENCY OVERRIDE

In arming mode, if remote control is failed or lost, please refer to following step for Emergency Override: Turn key to ON, press valet switch

5 times within 10 sec., siren will chirp 4 times, the system is then disarmed.

FUNCTION SELECTION

1. In disarming mode, turn ACC to ON, press valet switch 7 times within 8 sec. After 8 sec siren will chirp 1 time.

Then turn ACC OFF, LED will flash, press valet switch (siren will chirp once per press) until you get the numbers you want to change

the functions (within 10 sec.).

3. Turn ACC to ON, siren will chirp once or twice to indicate the functions you select. In case it chirps 3 times to indicate input failed.

NO. FUNCTION SELECTION PRESET (CHIRP ONCE) VARABLE (CHIRP TWICE)

1 AUTO REARMING YES NO

2 ANTI MOTORCYCLE-JACKING YES NO

Notice :

The changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate

the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.