Computer Hardware User Manual

Part 9
SEPARATING MAIN UNIT
In order to settle the touch terminal properly in a point of service
system, all the cable connections have to be routed through its base, either slim
or universal. Therefore, please observe the procedures from A to C below to
separate the main unit from both slim and universal base stand assembly after
all cables in cable cover disconnected.
OPENING STAND ASSEMBLY
Take the
adjustable stand
assembly and turn it up
side down to show the
bottom of the base.
Remove the bottom
plate fixing screw and
push the bottom plate to
the right as in these two
example pictures at both
sides to open.
Take
the bottom plate
up and the
inside of an
example slim
base model
looks like this
in the left
picture. The
inside of an
example
universal base
Step A: Prepare a soft clean flat surface, such
as a piece of cloth on the desk to seat
the front surface of main unit
Step C: Slide the base stand assembly to
left to
separate
C
A
B
C
A
B
Step B: Press the Lock/Release button and
meantime ...
Bottom Plate
Fixing Screw
Push Bottom
Plate This
Way To Open
Auxiliary
Cable Exit
Slim base bottom
Bottom Plate
Fixing Screw
Push Bottom
Plate This Way
To Open
Universal base bottom
6
8
4
3
10
7
9
2
11
5
6
1 8
Inside universal base
6
4
12 1 11
2
5
Inside slim base
13