Printer User Manual

Part 4
Switch Position 1 2 3 4 5 6 7 8
Serial interface
w/ auto cutter
OFF OFF OFF OFF OFF OFF OFF OFF
Parallel interface
w/ auto cutter
ON ON OFF OFF OFF OFF OFF OFF
C. INTERNAL SWITCH
There is an extra internal 4 position DIP switch in PP-7000-III
series for more technical settings. To access these setup, please first
turn off the printer power and disconnect every cable from the printer.
Remove 4 screws from bottom of printer and remove the plastic bottom
cover with the power switch pressed. The 4 position DIP switch seats
beside the 8 position DIP switch for setup window with the switch
position counting starts from the nearest side to the 8 position DIP
switch.
This 4 position DIP switch works as following:
Switch position Setting Effect
ê
Function ON OFF
1 Factory internal setting Disable Default
2 Paper width 58 mm 80 mm
3 Line format 576 dots / line 512 dots / line
4 Reserved N. A. N. A.
The Switch position 1 default set to ON. The print speed is fixed
at 42.5 lines/sec.
Switch position 2 is usually set to OFF for use with 80 mm paper
width. When the printer is installed with the 58 mm paper guide adaptor
for use with the paper roll of 58 mm width, the switch should be set to
ON in PP-7000-III & PP-7000U-III.
Switch position 3 is usually set to OFF for ESC/POS command
application that prints at 512 dots / line. Only technical users shall set
this switch to ON and make the printer work in the 576 dots / line
format.
D. SOFTWARE COMMANDS
The Aura thermal printer supports all commands applicable to
Epson printer TM-T88III. The only difference is the smoothening
command in enlarged text fonts. Please visit our web site
http://www.posiflex.com or http://www.posiflex.com.tw for detail