Printer User Manual

Part 6
bell onto say a kitchen wall, connect the cable from the bell to the
peripheral connector on the printer. Then use this command with m set
to 0 and both n1 and n2 set to 255. The printer will be able to drive the
kitchen bell for about half a second on each such command. If this
command is sent to the printer multiple times consecutively, the bell
will ring for about half a second and rest for also about half a second
then ring again for multiple times.
GS ‘p’ m n: Beep when cash drawer remain open (0 < m <
256, n = ‘0’ or ‘1’)
Hexadecimal codes are: 1D 70 m n
If the cash drawer connected to the printer remains open for more
than m seconds, the printer beeps until the drawer is closed. If m = 0,
this function is disabled. The factory default of the printer is set to
disable this function. The parameter n in this command identifies the
way cash drawer indicates drawer open status. n = ‘0’ (30H) applies
to drawers giving an “open” signal when cash drawer is opened. n =
‘1’ (31H) applies to drawers giving a “short” signal when drawer is
opened. Any value of the parameters outside the defined range will
cause the entire command ignored.
E. CHARACTER CODE PAGES
Aura PP-7000-III & PP-7000U-III series support all code pages
and international character sets applicable to Epson printer TM-T88.
There are five models for character sets application as standard model,
European model, Greek model, Arabic model and Lithuanian model
Page 0 (PC437: USA for Standard / European / Greek / Arabic /
Lithuanian model)
Page 1 (Katakana for Standard / Arabic / Lithuanian model)
Page 2 (PC850: Multilingual for Standard / European / Greek / Arabic /
Lithuanian model)
Page 3 (PC860: Portuguese for Standard / European / Greek / Arabic /
Lithuanian model)
Page 4 (PC863: Canadian-French for Standard / Arabic model)
Page 5 (PC865: Nordic for Standard / Arabic / Lithuanian model)
Page 17 (PC866: Cyrillic #2 for European / Greek model)
Page 18 (PC852: Latin II for European / Greek model)