- POSIFLEX POS PRINTER USER'S MANUAL

3 - 1
III. MAINTENANCE GUIDES
A. MAINTENANCE GUIDE LINES
B. GENERAL CLEANING
Please use a soft hair brush or compressed air to clear away
any dust or paper scraps accumulation inside the printer. Check
also the area of the auto-cutter regularly.
C. TROUBLE SHOOTING
This section gives solutions to some printer problems you
may have.
1. General Problems
No LED lights up on control panel when switched on –
Make sure that the power supply cables are correctly plugged into
the printer, the power adaptor and to the power outlet. Make sure
that power is supplied to the power outlet. If the power outlet is
controlled by a switch or timer, try use another outlet.
Do not touch the print head and motor after printing.
It can become very hot.
Never use benzene, benzine, thinner, trichloroethylene
alcohol, or ketone based solvents on the printer’s plastic and
rubber components.
Always turn off and disconnect power before start.
Please pay attention not to be hurt by any sharp edge of the
metal parts when handling the interior of the printer.