User's Manual
Page 2
After finish these steps, please fix the SD-800 which in the occupied by the cover originally on
back of the right side of main unit.
For optional Wi-Fi module, it will come separately with SD-800. Please follow procedures
from A to D to install the SD-800 installation.
(A) Please unfastens the screws which fix the bottom cover.
(B) Open the plastic bottom cover as arrowed direction in the picture B and separate it from the
main unit.
(C) Please unfastens the rubber block which squared in the picture C.
(D) Insert the USB Wi-Fi module into the internal USB port.
(E) Put the rubber block back and fasten the screw as picture E.
After finished these steps, please put the bottom cover back and fasten the screws.
DRIVER INSTALLATION
1.
For MSR: The magnetic stripe reader in SD-800 connects to the host through the
proprietary internal USB connecter working as a USB KB and therefore requires no driver
installation. For application in OS other than Windows (such as MS-DOS or Linux), some
technical internal modifications will be required and it is most advised to specify such
conditions clearly when ordering the SD-800. For application in MS-DOS, please enable
the USB keyboard and set USB operation mode to Full/Low Speed in system CMOS setup.
Refer to “Operation Guide” for manipulation over the reader configuration.
2.
For RFID Reader: Posiflex delivers this SD-800 with its drivers. Please find the driver’s
INF file in the CD or DVD which delivered with SD-800. Additionally, please notice that
SD-800’s RFID reader is not support the applications in OS other than Windows (such as
MS-DOS or Linux).
III. OPERATION GUIDE
MAGNETIC STRIPE READER
For magnetic stripe card reading, be sure to insert the card to the bottom with magnetic stripe
facing the mark aside the slot. The movement of the card can be either inserting the card from
the top to down out or sliding the card upward from the lower side to the top end as long as the
card is a standard one.
The MSR in SD-800 reads an ISO or JIS magnetic stripe card without driver. Yet, there is a
“Posiflex USB MSR Manager” program provided to control some parameter configuration for
ISO MSR. The features controllable in this program cover: each track enable/disable, Alt+Num
approach for ASCII codes and Leading/Stop code enable/disable. The function for enabling
each track of course comes in effect only when the track is physically available. Please find in
the Product Information CD or DVD delivered with KS system the folder
“\Drivers\SD_Series\USBMSR_xxx” and “SetUp” this manager program or download the
installation program from our web http://www.posiflex.com or http://www.posiflex.com.tw.
RFID Reader
The RFID reader is a radio-enabled device that communicates with a tag and with
the host system. In order to communicate with each other, the reader and the tag
must be set at same frequency and the tag must be within the reader’s RF range
as circled in the right picture. Various tags are available for use in different
applications and environments as well as can add data to the tag or the existing
tag data can modify.
Combinations of SD-800
There are few combinations of SD-800 for customer to choose:
1. MSR, Wi-Fi and RFID.
2. MSR and Wi-Fi.
3. MSR.
4. MSR and RFID.
5. RFID only for KS series except KS-61/63 series, KS-6812 and KS-2010.
For more information about options of SD-800, please go to
www.posiflex.com or contact
your local dealer.
A
B
C
D
E