Datasheet

ManualsBrandsPOSITAL FRABA ManualsSensorsMulti-turn Rotary encoder Magnetic Clamping flange

Printed at 11-06-2015 18:06

- 1 -

IXARC Rotary Encoder

MCD-AC005-0412-M10A-2AW

Interface

Interface Analog Current

Manual Functions Start and End point via Cable or Connector

Outputs

Electrical Data

Supply Voltage 15 – 30 VDC (On power supplies comply with EN 50178)

Current Consumption Typical 40 mA

Start-Up Time < 250 ms

Max Load Resistance 500 Ω (Max. value for supply voltage of 15 V. For higher

supply voltage higher load resistances can be used)

Linearity 0.15%

Analog Accuracy @ 4 mA = ±10µA; @ 20 mA = ±50 µA

Settling Time 80 ms

Reverse Polarity Protection Yes

Short Circuit Protection Yes

EMC: Emitted Interference DIN EN 61000-6-4

EMC: Noise Immunity DIN EN 61000-6-2

MTTF 283.3 years @ 40 °C

Sensor

Technology Magnetic

Resolution Singleturn 12 bit

Summary of content (4 pages)

PAGE 1
IXARC Rotary Encoder MCD-AC005-0412-M10A-2AW Interface Interface Analog Current Manual Functions Start and End point via Cable or Connector Outputs Electrical Data Supply Voltage 15 – 30 VDC (On power supplies comply with EN 50178) Current Consumption Typical 40 mA Start-Up Time < 250 ms Max Load Resistance 500 Ω (Max. value for supply voltage of 15 V. For higher supply voltage higher load resistances can be used) Linearity 0.
PAGE 2
Resolution Multiturn 4 bit Multiturn Technology Self Powered Magnetic Pulse Counter (No Battery, Wiegand Sensor) Accuracy (INL) ±0.36° Sense Signal (Default) Counterclockwise shaft movement (front view on shaft) Code Analog Current 4 – 20 mA Minimum Measurement Range 0 – 22.5° Resolution of Output Max. 12 bits over entire measureing range (Fractional Turns - Resolution decreases less than 12 bits when measurements range is less than 90 degrees) Multiturn Range 16 turn (default setting).
PAGE 3
Cable Length 2 m [79"] Wire Cross Section 0.14 mm² / AWG 26 Material / Type PVC Cable Diameter 6 mm (0.24 in) Minimum Bend Radius 30 mm (1.18 in) fixed, 60 mm (2.
PAGE 4
Contact FRABA America +1 (609) 750-8705 info@fraba.com FRABA Europe +49 (0) 221 96213-0 info@fraba.eu FRABA Asia +65 6514-8880 info@fraba.sg The picture and drawing are for general presentation purposes only. Please refer to the "Download" section for detailed technical drawings. All dimension in [inch] mm. © FRABA B.V., All rights reserved. We do not assume responsibility for technical inaccuracies or omissions. Specifications are subject to change without notice.