Datasheet

Printed at 11-06-2015 18:06

- 1 -

IXARC Rotary Encoder

MCD-AV002-0012-V06A-2AW

Interface

Interface Analog Voltage

Manual Functions Start and End point via Cable or Connector

Outputs

Electrical Data

Supply Voltage 12 – 30 VDC (On power supplies comply with EN 50178)

Current Consumption Typical 15 mA

Start-Up Time < 250 ms

Min. Load Resistance 10 KΩ (Min. value for supply voltage 12 V. For higher

supply voltage lower load resistances can be used)

Linearity 0.15%

Analog Accuracy @ 5V = ± 15 mV; @10 V = ±25 mV

Settling Time 80 ms

Reverse Polarity Protection Yes

Short Circuit Protection Yes

EMC: Emitted Interference DIN EN 61000-6-4

EMC: Noise Immunity DIN EN 61000-6-2

MTTF 283.3 years @ 40 °C

Sensor

Technology Magnetic

Resolution Singleturn 12 bit

PAGE 1
IXARC Rotary Encoder MCD-AV002-0012-V06A-2AW Interface Interface Analog Voltage Manual Functions Start and End point via Cable or Connector Outputs Electrical Data Supply Voltage 12 – 30 VDC (On power supplies comply with EN 50178) Current Consumption Typical 15 mA Start-Up Time < 250 ms Min. Load Resistance 10 KΩ (Min. value for supply voltage 12 V. For higher supply voltage lower load resistances can be used) Linearity 0.
PAGE 2
Accuracy (INL) ±0.36° Sense Signal (Default) Counterclockwise shaft movement (front view on shaft) Code Analog Voltage 0 – 10 V Minimum Measurement Range 0 – 22.5° Resolution of Output Max.
PAGE 3
SIGNAL CABLE COLOR Power Supply Red GND Yellow Voltage Output Green Set1 Brown Set2 White Not Connected Blue Not Connected Gray Not Connected Pink Shielding Shield Connector-View on Encoder Dimensional Drawing Contact Printed at 11-06-2015 18:06 -3-
PAGE 4
FRABA America +1 (609) 750-8705 info@fraba.com FRABA Europe +49 (0) 221 96213-0 info@fraba.eu FRABA Asia +65 6514-8880 info@fraba.sg The picture and drawing are for general presentation purposes only. Please refer to the "Download" section for detailed technical drawings. All dimension in [inch] mm. © FRABA B.V., All rights reserved. We do not assume responsibility for technical inaccuracies or omissions. Specifications are subject to change without notice.