Datasheet

ManualsBrandsPOSITAL FRABA ManualsSensorsMulti-turn Rotary encoder Optical Synchro flange

Printed at 11-06-2015 16:06

- 1 -

IXARC Rotary Encoder

OCD-DPC1B-1416-S06S-H3P

Interface

Interface Profibus DP

Profile DPV0, DPV1 and DPV2 Class 2 (EN50170 + EN50254)

Diagnostics Memory

Programming Functions Resolution, gearing factor (physical resolution) , velocity

scaling + filter, preset (zero point), counting direction,

limit switches , node number, teach-in, diagnosis

Manual Functions Address selector switch 0-99 and terminal resistor (with

connection cap)

Transmission Rate ≤12 Mbaud

Interface Cycle Time > 1 ms

Outputs

Output Driver Profibus Data Interface, galvanically isolated via

opto-couplers

Electrical Data

Supply Voltage 10 – 30 VDC (On power supplies comply with EN 50178)

Current Consumption ≤ 230 mA @ 10 V DC, ≤ 100 mA @ 24 V DC

Power Consumption ≤ 2.5 W

Start-Up Time < 1 s

Reverse Polarity Protection Yes

Short Circuit Protection Yes

EMC: Emitted Interference DIN EN 61000-6-4

EMC: Noise Immunity DIN EN 61000-6-2

Summary of content (4 pages)

PAGE 1
IXARC Rotary Encoder OCD-DPC1B-1416-S06S-H3P Interface Interface Profibus DP Profile DPV0, DPV1 and DPV2 Class 2 (EN50170 + EN50254) Diagnostics Memory Programming Functions Resolution, gearing factor (physical resolution) , velocity scaling + filter, preset (zero point), counting direction, limit switches , node number, teach-in, diagnosis Manual Functions Address selector switch 0-99 and terminal resistor (with connection cap) Transmission Rate ≤12 Mbaud Interface Cycle Time > 1 ms Outputs
PAGE 2
MTTF 13.5 years @ 40 °C Electrical Lifetime >10⁵ h Sensor Technology Optical Resolution Singleturn 16 bit Resolution Multiturn 14 bit Multiturn Technology Mechanical Gearing (no Battery) Accuracy (INL) ±0.0220° (14 – 16 bit), ±0.
PAGE 3
Connection Orientation Radial Connection Type 3 x Cable Gland Connection Cap Type Removable for easy replacing encoder without new installation of cable, Rotary switches with visible node number, No active components, Terminal resistor switch cut the outgoing bus too, Big spring clips Connection Plan SIGNAL PIN NUMBER Bus line B (Bus in) B Bus line A (Bus in) A GND − Power Supply + Bus line B (Bus out) B Bus line A (Bus out) A GND − Power Supply + Connector-View on Encoder Dimensiona
PAGE 4
Contact FRABA America +1 (609) 750-8705 info@fraba.com FRABA Europe +49 (0) 221 96213-0 info@fraba.eu FRABA Asia +65 6514-8880 info@fraba.sg The picture and drawing are for general presentation purposes only. Please refer to the "Download" section for detailed technical drawings. All dimension in [inch] mm. © FRABA B.V., All rights reserved. We do not assume responsibility for technical inaccuracies or omissions. Specifications are subject to change without notice.