FJ1000LS FJ1000LS User Manual Positioning Universal 1
FJ1000LS Contents 1 Introduction ....................................................................................................................3 1.1ID and Tooling Design.......................................................................................................3 2 Hardware.........................................................................................................................3 2.1 Physical and Electrical Specifications .......................................................
FJ1000LS 1.1 ID and Tooling Design Dimensions: 80.5mm*52mm*18mm Weight: 60g (with optional battery) 2.1Physical and Electrical Specifications Input Voltage: 7-30VDC Power consumption: - Active mode: 100mA @12VDC - Sleep mode: <8mA @12VDC Operating temperature: -30℃ to 80℃ Storage temperature: -40℃to 85℃ 2.2Input/Output Download and debug port: 1 SWDInterface: 1 Function LEDs: 2 2.3 Cellular Communication Operation mode :LTE/GPS Operation band :LTEB12/B25/B26;GPS 1.57542GHz Modulation: QPSK/16QAM 2.
FJ1000LS 2.
FJ1000LS 1.One UART cables. 2.The FJ1000LS devices.
FJ1000LS 3.One DC 12V cable. 3.3 Description. 1.Connect the UART cable to the UART interface of MCU on the device, the other side connect to PC, you can communication to MCU with UART cable.
FJ1000LS 2. Connect the DC 12V cable to the connector of J203 on the device, the other side connect to DC 12V, you can use the DC 12v cable to supply power. 4. The other interfaces of the FJ1000LS device are shown in the following pictures.(The Modem UART 1 on device is for modem debug and update firmware).
FJ1000LS mcu download test point GPS UART test point 8
FJ1000LS NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.