User Manual

WIRED VERSION

1. Plug the USB cable into an empty USB port.

WIRELESS VERSION

2.4 GHz USB Micro Receiver

The micro receiver is located inside the housing on the underneath of the Penguin (J).

1. Remove the micro receiver and insert into a spare USB port of your computer or

laptop.

2. Make sure the ON/OFF switch (F) on the base is in the ‘ON’ position.

On/off switch

For normal working conditions, make sure the ON/OFF switch (F) is turned to the

‘ON’ position. The ON/OFF switch is located on the base of the Penguin.

Note: It is advised to switch to the ‘OFF’ position if the Penguin is to be transported

as this will conserve power.

Auto power save

There is an auto ‘power save’ with the Wireless Penguin that will turn the illuminated

‘P’ logo off after approximately 20 seconds of the mouse being inactive. When the

Penguin is moved, the ‘P’ logo will re-illuminate and the mouse will be active.

Rechargeable battery

The Wireless Penguin has an internal rechargeable battery. There may be a certain

amount of charge already in the battery.

To fully charge the battery, insert the USB end of the cable (G) into a spare USB port

of your computer and the DC end of the cable into the front of your mouse (I) see

diagram. Refer to the Charging Light Sequence section to indicate the battery level.

Rechargeable battery low power level indicator

Ice Blue light ﬂashing Low battery (approximately 20% charge remaining)

Charging light sequence

When the charging cable is connected, a series of coloured lights in the illuminated

‘P’ logo will indicate different battery levels.