Owner's Manual
MKT. #8830017 - REV C
06/13
PRINTED IN USA PAGE 2 OF 2
Operation
The FHA is an analog/addressable sensor that uses one address on the Signaling Line Circuit (SLC) of a compatible re alarm control panel. The
unit communicates with the control panel as it is polled. The LEDs ash every time the unit is polled and they will latch steady if the unit is in
an active status.
The FHA is a single sensor that may be used in a wide variety of applications for property protection. The FHA has a high ambient installation
temperature and has been tested in these environments. The unit has a sleek design and low prole for pleasing aesthetics. The temperature
sensor is protected within the mold of the unit to prevent accidental damage
Compatible Bases
All bases will mount on a single gang, double gang, octagon, 4” square or mud ring electrical box.
Device Description
AB-4 4” Standard Base
AB-6 6” Standard Base
AIB 6” base with an isolator module included. The base is pre-wired with a pluggable jumper to the module.
ARB 6” base with a dual relay module included. One relay is rated for 8 amps at 240 VAC/30 VDC and the second is
rated for 2 amps at 240 VAC/30 VDC. The base is pre-wired with a pluggable jumper to the module.
ASB 6" base with sounder module included. Sound pattern is provided from external source. The base is pre-wired
with a pluggable jumper into the module.
FHA
FIXED TEMPERATURE
HEAT SENSOR
firealarmresources.com