Owner's Manual
MKT. #8830018 - REV C
06/13
PRINTED IN USA PAGE 2 OF 2
RHA
RATE OF RISE/FIXED TEMPERATURE
HEAT DETECTOR
Operation
The RHA is an analog/addressable sensor that uses one address on the Signaling Line Circuit (SLC) of a compatible re alarm control panel.
The unit communicates with the control panel as it is polled. The LEDs ash every time the unit is polled and they will latch steady if the unit is
in an active status.
The RHA is a single sensor that may be used in a wide variety of applications for property protection. The RHA has a the rate of rise heat
detection to provide detection of an escalating re. The unit has a sleek design and low prole for pleasing aesthetics. The temperature sensor is
protected within the mold of the unit to prevent accidental damage.
Compatible Bases
All bases will mount on a single gang, double gang, octagon, 4” square or mud ring electrical box.
Device Description
AB-4 4” Standard Base
AB-6 6” Standard Base
AIB 6” base with an isolator module included. The base is pre-wired with a pluggable jumper to the module.
ARB 6” base with a dual relay module included. One relay is rated for 8 amps at 240 VAC/30 VDC and the second is
rated for 2 amps at 240 VAC/30 VDC. The base is pre-wired with a pluggable jumper to the module.
ASB 6" base with sounder module included. Sound pattern is provided from external source. The base is pre-wired
with a pluggable jumper into the module.
firealarmresources.com