Assembly Instruction

pottery barn kids

ADIRONDACK SIDE TABLE

PRE-ASSEMBLY:

• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly

when used in conjunction with the assembly instructions.

• For your safety and ease, assembly by two adults is recommended.

• Remove all part and hardware from the box and lay out on a clean, carpeted, or scratch- free work

surface. Use care as some parts or hardware may have sharp points or edges.

• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts

and hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may

cause the bolts misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split

wood.

PARTS INCLUDED:

(A) Table Top (1)

(B) Table Leg (4)

HARDWARE INCLUDED:

(D) Flat Washer (4)

(E) Spring Washer (4)

(F) Nut (4)

(G) Wrench (1)

(H) Bolt 40mm (4)

(I) 4mm Allen Key (1)

ASSEMBLY INSTRUCTIONS:

1. Secure the each leg (B) with 1 Washer (D), 1 Spring washer (E), and 1 Nut (F), as shown in Figure 1

using Wrench. Do not tighten the nuts at this point.

(Fig.1)

D E F G

PAGE 1
pottery barn kids ADIRONDACK SIDE TABLE PRE-ASSEMBLY: • Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions. • For your safety and ease, assembly by two adults is recommended. • Remove all part and hardware from the box and lay out on a clean, carpeted, or scratch- free work surface. Use care as some parts or hardware may have sharp points or edges.
PAGE 2
. Attach the connectors (C) to the leg (B) as shown, and secure with bolts (H). I (Fig.2) H C H I 3. . Tighten all nuts and bolts. Turn the piece upright. Assembly is complete (Fig.2) CARE INSTRUCTIONS: • For daily care wipe with a soft dry cloth. Blot Spills immediately and wipe with a clean dry cloth. • Store in a dry, covered area when not in use. • We do not recommend the use of chemical cleansers, abrasives, or furniture polish. • Over time, the product may begin to turn gray.