Assembly Instruction

Page 1/3

pottery barn kids

BERKELEY DRAWER CHEST

PRE-ASSEMBLY:

• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used

in conjunction with the assembly instructions.

• For your safety and ease, assembly by two adults is recommended.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use

care as some parts or hardware may have sharp points or edges.

• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or

hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.

PARTS INCLUDED:

(A) Drawer Chest - 1pc

(B) Leg - 4pcs

TOOLS REQUIRED:

Phillips head screwdriver (not included)

ASSEMBLY INSTRUCTIONS:

1. Lay the Drawer Chest (A) down on a soft surface. Attach the Legs (B) to the Drawer Chest (A) as shown in

Figure 1.

(Fig. 1)

PAGE 1
pottery barn kids BERKELEY DRAWER CHEST PRE-ASSEMBLY: • Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions. • For your safety and ease, assembly by two adults is recommended. • Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use care as some parts or hardware may have sharp points or edges.
PAGE 2
. Turn the Drawer Chest (A) upright. Pull out all the drawers. The wooden knobs are pre-attached at the back of drawer fronts. Use Phillips head screwdriver (not included) to turn the screw counter clockwise until remove knob from drawer front. Repeat until all Knobs are detached (see Fig. 2). (Fig.2) 3. Fasten knobs to drawers using Phillips Head screwdriver, as shown in the figure below. Repeat until all knobs are attached. (see Fig. 3). (Fig.
PAGE 3
4. If your floor is not perfectly even, the furniture may not sit level. If the piece is not level, determine which corner does not touch the ground correctly. Follow these steps: • Carefully elevate the item slightly to provide access to the levelers attached to the bottom. • Turn the levelers in a counter-clockwise direction. • Gently set down the piece and check stability. • Repeat steps until the furniture sits firmly on the ground (see Fig. 4). (Fig.