Assembly Instruction

pottery barn kids
CAMERON ART CUBBY
IMPORTANT SAFETY INSTRUCTIONS:
Please read all instructions carefully before assembling.
For your safety, assembly by two people is recommended.
PART LIST
(A) Top Panel - 1 pc
(B) Bottom Panel - 1 pc
(C) Shelf - 1 pc
(D) Outer Side Board - 2 pcs
(E) Back Panel - 1 pc
(F) Insert Shelf - 2 pcs
(G) Inner Side Board - 2 pcs
HARDWARE LIST
(H) Allen Key
- 1 pc
(I. Bolt ¼“ x 30mm
- 8 pcs
(J. Spring Washer ¼“
- 8 pcs
(K. Flat Washer ¼“
- 8 pcs
(L) Connecting Bracket
- 2
pcs
(M) Screw (for C. Bracket)
- 12
pcs
(N) Plastic Restraint
- 1 pc
(O) Plastic Wall Bracket
- 2
pcs
(P) Long Screw
- 2 pcs
(Q). Short Screw
- 2 pcs
(S) Square Bracket
- 1 pc
(T) Screw (for S. Bracket)
- 4 pcs
PRE-ASSEMBLY:
• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface,
as this will avoid damaging any parts during assembly. The shipping box provides an ideal work surface. Do
not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.
• Use the parts and hardware lists above to identify and separate each of the pieces included.
• The illustrations provided allow for easier assembly when used in conjunction with the assembly
instructions.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause
the bolts to misalign during assembly.
• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split
wood.
ASSEMBLY INSTRUCTIONS:
1. Carefully attach Outer Side Boards (D) to Shelf (C) as shown in Fig 1.
2. Slide the Back Panel (E) into the slots on the backside of the Outer Side Panels. Attach the Bottom Panel
(B) as shown using (4) Allen Bolts (I), Flat Washers (K) & Spring Washers (J). Note: The correct order for
the washers to go on the Allen Bolt is: Spring Washer first, Flat Washer second. Please see Fig. 2.
3. Set the Top Panel (A) on the already assembled pieces and secure with remaining 4 Allen Bolts (I), Flat
Washers (K) & Spring Washers (J). Please see Fig. 3.
4. Place (2) Insert Shelf (F) to the slots on the Inner Side Board (G) and slide into the bottom compartment of
the assembled piece. Please see Fig 4.
5. If connecting Art Cubby piece to Base piece use (12) Screws (M) and (2) Connecting Brackets (L) as
shown. Screws are self-drilling and are designed to go into wood easily
6. If connecting Art Cubby piece to Cubby piece use (4) screws (T) and (1) Square Connecting Bracket (S)
as shown. Screws are self-drilling and are designed to go into wood easily.
7. Fully tighten all the screws and bolts to complete the assembly.
8. For Anti Tip Kit, please see separate instructions.
CARE INSTRUCTIONS:
• Dust with a clean, soft cloth.
• Avoid the use of chemicals and harsh cleaning agents.
• Do not climb on the Cubby.
Thank you for your purchase.
stores | catalog | www.potterybarnkids.com