Assembly Instruction

Page 1/3

pottery barn kids

CAMERON 1 SHELF BOOKCASE

IMPORTANT SAFETY INSTRUCTIONS:

Please read all instructions carefully before assembling.

For your safety, assembly by two adults is recommended.

HARDWARE INCLUDED:

(F) Allen Key – 1pc

(G) Allen Bolt ¼” x 28mm – 8pcs

(H) Spring Washer ¼” – 8pcs

(I) Flat Washer ¼” – 8pcs

(J) Wood Screw 3 x 15mm – 6pcs

PRE-ASSEMBLY:

• The illustrations provided allow for easier assembly when used in conjunction with the assembly

instructions.

• Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface, as this

will avoid damaging any parts during assembly. The shipping box provides and ideal work surface. Do not

dispose of any contents until assembly is completed to avoid accidentally discarding small parts or

hardware.

• Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or

hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included prior to starting

assembly.

• Note: DO not fully tighten all bolts until all parts are in place. Failure to follow these instructions may

cause the bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware of split

wood.

CARE INSTRUCTIONS:

• Dust often using a clean, soft, dry lint-free cloth.

• Blot spills immediately, and wipe with a clean, damp, cloth.

• We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered

finish.

PARTS INCLUDED:

(A) Top Panel – 1pc

(B) Bottom Panel – 1pc

(D) Right Side Panel – 1pc

(E) Back Panel – 1pc

TOOLS REQUIRED:

Philips Screwdriver (Not included)

PAGE 1
pottery barn kids CAMERON 1 SHELF BOOKCASE IMPORTANT SAFETY INSTRUCTIONS: Please read all instructions carefully before assembling. For your safety, assembly by two adults is recommended.
PAGE 2
ASSEMBLY INSTRUCTIONS: 1. Connect the Bottom Panel (B) to the Left Side Panel (C) by aligning the pre-drilled holes on the cleats of the Bottom Panel (B) to those of the Left Side Panel (C). Secure by inserting an Allen Bolts (G) through a Spring Washer (H) and a Flat Washer (I) through the pre-drilled holes on the cleats of the Bottom Panel (B) and into the pre-drilled holes of the Left Side Panel (C) using the Allen Key (F). B. F. G. H. I. C. 2.
PAGE 3
4. Place the Top Panel (A) on the assembled piece. Secure by inserting an Allen Bolt (G) through a Spring Washer (H) and a Flat Washer (I) through the pre-drilled holes on the cleats of the Left/Right Side Panel (C & D) and into those of the Top Panel (A) using the Allen Key (F). F. G. A. H. I. E. D. 5. Secure the Back Panel (E) to the Bottom Panel (B) and Top Panel (A) using (6) Wood Screws (J) and a Philips Screwdriver. Check alignments and tighten all bolts and screws. A. E. J.