Assembly Instruction
Page 1/3
C.
D.
B.
pottery barn kids
CAMERON CRAFT TABLE HUTCH
PRE-ASSEMBLY:
• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when
used in conjunction with the assembly instructions.
• For your safety and ease, assembly by two adults is recommended.
• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface.
Use care as some parts or hardware may have sharp points or edges.
• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.
• Use the parts and hardware lists to identify and separate each of the pieces included.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause
the bolts to misalign during assembly.
• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.
HARDWARE INCLUDED:
(G) Allen Key – 1pc
(H) Allen Bolt 1/4” x 28mm – 8pcs
(I) Spring Washer – 8pcs
(J) Flat Washer – 8pcs
(K) Square Bracket – 2pcs
(L) Wood Screw 3 x 12mm – 8pcs
ASSEMBLY INSTRUCTIONS:
1. Align and connect the wooden dowels on Left/Right Side Panels (C&D) to the pre-drilled holes on each
end of the Bottom Unit (B). Slide a Spring Washer (I), Flat Washer (J) onto an Allen Bolt (H). Insert the
Allen Bolt from bottom of the Bottom Unit (B) into the pre-drilled holes located on bottom of the Left/Right
Side Panels, using the Allen Key (G). Repeat with another (3) Allen Bolts. (Fig. 1)
Fig. 1
C.
D.
B.
F.
A.
E.
PARTS INCLUDED:
(A) Top Panel – 1pc
(B) Bottom Unit – 1pc
(C) Left Side Panel – 1pc
(D) Right Side Panel – 1pc
(E) Back Panel – 1pc
(F) Center Divider – 1pc
TOOLS REQUIRED:
Philips Screwdriver (Not included)