Assembly Instruction

ManualsBrandsPottery Barn ManualsHome OfficePottery Barn Farmhouse Desk

pottery barn kids

FARMHOUSE DESK

PRE

ASSEMBLY:



Please read all instruction before beginning assembly.

The illustrations provided allow for easier assembly

when used in conjunction with the assembly instructions.



Remove all parts and hardware from box and

lay out on a carpeted or scratch

free work

surface,

as t

his will

avoid damaging any parts during assembly. The shipping box provides and ideal work surface

Do not dispose

of any contents until assembly is completed to avoid accidentally discarding small p

arts or hardware.



For your safety and

ease, adult assembly

by t

wo people is recommended.



Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or

hardware.



Use the parts and hardware lists to identify and se

parate each of the pieces included prior to starting

assembly.



Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.



If using power tools to aid in assembly

please use caution. Power tools can damage hardware or split wood.

PARTS INCLUDED:

(

)

Table Top

(

) Leg

TOOLS

REQUIR

ED:

Phillips head screwdriver (not included)

HARDWARE

ENCLOSED

(

)

10x48mm Nuts

pcs

(

)

Bolts

pcs

(E)

Flat

Washer 1/4mm

–

8pcs

(F) Spring washer 1/4mm

–

8pcs

(G) Nuts 1/4mm

–

8pcs

(H) Spanner

–

1pc

Summary of content (3 pages)

PAGE 1
pottery barn kids FARMHOUSE DESK PRE-ASSEMBLY:  Please read all instruction before beginning assembly. The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.  Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface, as this will avoid damaging any parts during assembly. The shipping box provides and ideal work surface.
PAGE 2
ASSEMBLY INSTRUCTIONS: 1. 1. Insert the Bolts (D) into the pre-drilled holes on Leg (B) as shown. Insert the Bolts (D) into the pre-drilled holes on the top of the leg (B) to receive the Nut (C). Tighten with a screwdriver, but do not over tight. Repeat same process for the other 3 Legs. (Fig. 1) . (Fig. 1) C B D 2.Lay tabletop (A) face down on your work surface and position one of the Desk legs (B) exactly as shown in illustration below.
PAGE 3
. Adjust the Adjustable Levelers on the bottom of the Legs by loosening or tightening them so the Table sits evenly on floor. (Fig. 3) CARE INSTRUCTIONS:  Dust often using a clean, soft, dry lint-free cloth.  Blot spills immediately, and wipe with a clean, damp, cloth.  We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered finish. Thank you for your purchase stores | catalog | www.potterybarnkids.